firstexample:first_example_microzed_sysdev
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| firstexample:first_example_microzed_sysdev [2021/12/28 15:02] – ursgraf | firstexample:first_example_microzed_sysdev [2021/12/28 16:35] – [Step by Step Instructions] ursgraf | ||
|---|---|---|---|
| Line 7: | Line 7: | ||
| ===== Step by Step Instructions ===== | ===== Step by Step Instructions ===== | ||
| - Create a deep project and setup the project configuration as given in [[first_example_microzed|Hello World on the Avnet MicroZed Board]]. Make sure that you have set the OpenOCD command and command options so that it suits your installation, | - Create a deep project and setup the project configuration as given in [[first_example_microzed|Hello World on the Avnet MicroZed Board]]. Make sure that you have set the OpenOCD command and command options so that it suits your installation, | ||
| - | - If you need a valid configuration in your FPGA part (e.g. you are using flink devices), you must select a configuration file for the PL. \\ {{ chooseplfile.png? | + | - If you need a valid configuration in your FPGA part (e.g. you are using flink devices), you must select a configuration file for the PL. \\ {{ chooseplfile.png? |
| - Set the jumpers on your MicroZed board as follows \\ {{ jtagboot.png? | - Set the jumpers on your MicroZed board as follows \\ {{ jtagboot.png? | ||
| - Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers. | - Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers. | ||
| - When creating the run configuration, | - When creating the run configuration, | ||
| + | - //Run// will compile, link and download the image file. See [[firstexample: | ||
| ===== How Does the System Boot? ===== | ===== How Does the System Boot? ===== | ||
| - reset (by JTAG) | - reset (by JTAG) | ||
firstexample/first_example_microzed_sysdev.txt · Last modified: 2022/11/24 16:23 by ursgraf
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
