This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
firstexample:first_example_microzed_deploy [2022/02/16 15:59] – [Deploying] ursgraf | firstexample:first_example_microzed_deploy [2022/08/22 08:35] – ursgraf | ||
---|---|---|---|
Line 15: | Line 15: | ||
==== Using the SD Card ==== | ==== Using the SD Card ==== | ||
- Copy the above generated file // | - Copy the above generated file // | ||
- | - Set the jumpers on your MicroZed board as follows \\ {{ sdboot.png? | + | - Set the jumpers on your MicroZed board as follows \\ {{ sdboot.png? |
- Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board) will reset the board but will not sample the boot mode pins connected to the jumpers. | - Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board) will reset the board but will not sample the boot mode pins connected to the jumpers. | ||