This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
firstexample:first_example_microzed_deploy [2021/12/30 09:44] – ursgraf | firstexample:first_example_microzed_deploy [2022/01/06 17:13] – mlammerich | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Deploying ====== | ====== Deploying ====== | ||
<box green 100%> | <box green 100%> | ||
- | As soon as you are done with your development, | + | As soon as you are done with your development, |
</ | </ | ||
- | The application | + | The application |
===== Step by Step Instructions ===== | ===== Step by Step Instructions ===== | ||
Line 16: | Line 16: | ||
- Copy the above generated file // | - Copy the above generated file // | ||
- Set the jumpers on your MicroZed board as follows \\ {{ sdboot.png? | - Set the jumpers on your MicroZed board as follows \\ {{ sdboot.png? | ||
- | - Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers. | + | - Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board) will reset the board but will not sample the boot mode pins connected to the jumpers. |
==== Using the QSPI Flash ==== | ==== Using the QSPI Flash ==== | ||
- | - Follow the steps given in [[firstexample: | + | - Follow the steps given in [[firstexample: |
- Set the jumpers on your MicroZed board as follows \\ {{ qspiboot.png? | - Set the jumpers on your MicroZed board as follows \\ {{ qspiboot.png? | ||
- Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers. | - Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers. |