This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
firstexample:first_example_microzed_deploy [2021/12/28 15:41] – [Step by Step Instructions] ursgraf | firstexample:first_example_microzed_deploy [2022/08/22 08:35] – ursgraf | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Deploying ====== | ====== Deploying ====== | ||
<box green 100%> | <box green 100%> | ||
- | As soon as you are done with your development, | + | As soon as you are done with your development, |
</ | </ | ||
- | The application | + | The application |
===== Step by Step Instructions ===== | ===== Step by Step Instructions ===== | ||
Line 12: | Line 12: | ||
- Running the configuration will create two flash files. Its location is given by the image file setting in the configuration. They carry the names // | - Running the configuration will create two flash files. Its location is given by the image file setting in the configuration. They carry the names // | ||
- Now, you have to choose between using a SD card or the QSPI flash. | - Now, you have to choose between using a SD card or the QSPI flash. | ||
+ | |||
==== Using the SD Card ==== | ==== Using the SD Card ==== | ||
+ | - Copy the above generated file // | ||
+ | - Set the jumpers on your MicroZed board as follows \\ {{ sdboot.png? | ||
+ | - Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board) will reset the board but will not sample the boot mode pins connected to the jumpers. | ||
==== Using the QSPI Flash ==== | ==== Using the QSPI Flash ==== | ||
- | + | | |
- | | + | - Set the jumpers on your MicroZed board as follows \\ {{ qspiboot.png? |
- | - The program to download can be found in the binaries of //Vivado// or the //Xilinx SDK//. You have to either install //Vivado// or //Xilinx SDK// which doesn' | + | |
- | - Switch the driver for the JTAG-HS3 back to //WinUSB//, see [[https:// | + | |
- | - Set the jumpers on your MicroZed board as follows \\ {{ qspiboot.png? | + | |
- Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers. | - Cycle the power. The settings of the jumpers will be read only at power-on! Hence, make sure to cycle the supply power after changing the jumper settings. A soft reset (through the JTAG or by pressing the reset button on the board will reset the board but will not sample the boot mode pins connected to the jumpers. | ||